With the re outbreak of the wave of large-scale infrastructure construction due to the impact of the epidemic, concrete transportation has become one of the hottest transportation tasks at present, not only driving the sales of concrete mixer trucks, but also attracting a large number of people to join the infrastructure transportation industry. Next, in order to better understand it, let's learn about the common problems and treatment of mixer truck parts.
1、 What is the tug of concrete mixer?
The mixer trailer is a bearing, which is used to support the tank and is integrated with the mixer to assist mixing.
2、 What is the tug of the mixer?
Generally, it is not recommended to replace it by yourself. Go directly to the after-sales point to find a special person to replace it. The oil used must meet the requirements, otherwise the equipment will be greatly damaged and the service life will be greatly shortened. Replace the hydraulic oil with a reasonable grade.
3、 What is the relationship between the filling rate of the concrete mixer tank and the inclination of the tank?
At present, the inclination angle of the mixer truck is about 12 degrees, and the filling rate is about 63%. It is difficult to measure the inclination angle and calculate the filling rate. The mixer trucks sold at present are subject to the useful mixing volume.
4、 What is the reason why the concrete mixer tank does not rotate and the hydraulic oil is sprayed out from the oil filler of the mailbox?
The hydraulic pressure goes in and out one by one. It may be that the sealing part of the oil pump is broken. The oil return is flushed. It may be that the sealing foot pad of the oil pump is damaged.
5、 What is the speed of the mixing drum of the mixer truck?
The rotating speed of the mixing drum during feeding is 6-10 rpm; Speed of mixing drum during mixing: 6-10 rpm.
6、 What is the distance from the feed port of 8-12 m3 concrete mixer truck to the ground?
Generally, the height of 8-12 square meters mixer truck is about 3.8 meters, and the distance between the feed inlet and the ground is about 3.5 meters, depending on different models.
7、 How does the mixer clean the tank?
For the water tank equipped with the mixer truck, the water shall be put into the tank after unloading each time, and the water shall be mixed when returning, and then discharged to the mixing station to receive the materials. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be directly cleaned with water in the water tank. If the cement slurry has set, find a special cleaning tank in the tank, and brush the surface with oxalic acid.
In addition, as a driver, you should always observe whether the can is rotating through the rear-view mirror, and adjust the speed as slow as possible. If the speed is too high, the vehicle is easy to swing. Although you have been careful at all times, there are still many accidents, so safe driving is very important. For more information, please visit our website http://www-zkzdsljbc-com.irwinroth.com Consult.