Summer is a season where fire accidents are easy to occur. No matter when you go out or work, you need to be careful. Especially in the field of mixer trucks, the occurrence of such accidents will not only threaten your own safety, but also cause certain losses to the company. Therefore, it is very important to do a good job in prevention. The full-automatic mixer manufacturer will tell you the content.
(1) Do not pour gasoline into the carburetor when the engine is running or when the vehicle is shaking. Fill the carburetor with gasoline to increase the concentration of the mixture in the cylinder. Although this is conducive to startup in case of failure of oil not entering the cylinder, it is not helpful to the failure caused by other reasons, and it may also cause backfire, burn personnel and burn vehicles.
(2) When maintaining the gasoline filter, it is not recommended to burn the filter core with gasoline. Many people like to burn ceramic filter element with gasoline to remove impurities on the filter element when maintaining the gasoline filter. The danger of this is that it is easy to catch fire and has an impact on the life of the filter element.
(3) In the oil depot, it is not allowed to use the method of short-circuit ignition to check the battery storage. Because in small oil depots with poor ventilation, equipment such as tires, batteries, tarpaulins and so on are often placed, and gasoline is scattered on the ground. The sparks generated during the fire are likely to ignite the oil molecules in the air.
(4) The towing iron chain of the oil tanker shall not be wound on the girder. Like other substances, oil will generate static electricity when it rubs against another object. This electrostatic fire may ignite the fuel and cause a fire. Therefore, a grounding wire shall be installed on the oil depot, and a grounding iron chain shall be installed on the oil tank truck to prevent static sparks in the oil tank. The iron chain shall not be wound on the girder frame at will, but shall be placed on the ground, and the towing section shall not be less than 50cm.
(5) It is not allowed to frequently use the hanging fire method. Sometimes there is carbon deposit in the spark plug of an automobile. When the carbon deposit of a certain cylinder is serious, the cylinder can not work normally. In order to make the cylinder work normally, the method of "hanging fire" outside the cylinder (leaving a gap of 3mm-4mm between the spark plug and the high-voltage line) is adopted to improve the energy of spark plug electrode and restore the cylinder to work.
However, the general "hanging fire" method is easy to fall off without paying attention. If there is gasoline dripping on the cylinder block, it is prone to fire. Therefore, it is only a temporary remedy. The correct treatment should be to clean and maintain the spark plug in time, and try to avoid using the "hanging fire" method.
There are several fire precautions for mixer trucks. You can use them as reference. For more precautions, please visit our website http://www-zkzdsljbc-com.irwinroth.com Consult and understand!